Temperature Limiting Control - e-Flame USA EF-BLT13-36 Owner's Manual

TEMPERATURE LIMITING CONTROL

This electric fireplace is equipped with a temperature limiting control device. Should he
fireplace reach an unsafe temperature, the unit will automatically turn off. To reset, turn
off and plug the unit, wait 5 minutes, and plug it back in again to continue use.
SYMPTOM
Fireplace doesn't work.
Flame is not moving.
Dim or poorly visible flames,
or pebbles
aren't glowing.
Flame sputters.
Remote control does not
work.
Circuit breaker trips, or fuse
blows when
the unit is on.
Heater does not provide
heat when turned on.
Unit turns off and will not
turn on.
POSSIBLE CAUSES
Fireplace inner
components are
overheating, or the home
circuit breaker has tripped.
Wiring may be loose, or
the flame's motor may be
defective.
LED lights are burnt out, or
the wiring is loose.
Flame's motor is defective.
Low battery. Master switch
is in "OFF" position.
Improper circuit current
rating.
Thermal switch has been
tripped, or circuit breaker
has been tripped.
Appliance has overheated
and its safety device has
caused the thermal switch
to disconnect, or house
circuit breaker has tripped.
10
SOLUTION
Reset switch by turning
master switch off and
waiting for 5 minutes,
then turning it back on.
Call Customer Service
for instructions.
Call Customer Service
for instructions.
Call Customer Service
for instructions.
Change the battery for
remote control. Check to
make sure the master
switch is turned on.
Call Customer Service
for instructions.
Turn the unit off and unplug
the unit for 5 minutes. Plug
back in and turn on the unit.
Turn off circuit breaker that
supplies electricity to the
unit, wait 5 minutes, then flip
circuit breaker back on.
Unplug the appliance, allow
to cool for 15 minutes, then
plug back in. Reset the
house circuit breaker.