Related Manuals for e-Flame USA EF-BLT11
Summary of Contents for e-Flame USA EF-BLT11
- Page 1 ELECTRIC FIREPLACE INSERT MODEL # EF-BLT11 NO VENTING REQUIRED PRODUCES SAFE EFFICIENT HEAT PLAEASE READ THIS ENTIRE INSTRUCTIONS MANUAL BEFORE USING 110-120VOLT 1500WATT SAVE THESE INSTRUCTIONS FOR FUTURE USE...
-
Page 2: Installation Instructions - General
Important: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty. INSTALLATION INSTRUCTIONS - GENERAL 1. Read all instructions before using this appliance. 2. - Page 3 LOCATING YOUR FIREPLACE When choosing a location for your new fireplace, ensure the general instructions are followed. Also, for best effect install the fireplace out of direct sunlight. It is safe to set the fireplace insert close to non-combustibles. DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VA PORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER A PPLIANCE.
- Page 4 1. Under no circumstances should this product be operated with broken glass. 2.Do not strike or slam the glass. 3.Do not use abrasive cleansers to clean the glass. 4,This product uses tempered glass. Replacement of the glass supplied by the manufacturer should be done by a qualified service person.
-
Page 5: Manual Controls
MANUAL CONTROLS The manual controls are located on the top right of the fireplace insert behind an access panel. You have the following controls: Turn on / off the device Press the touch power button. Touch the touch button -turn on the unit, the heater starts, showing 1. -
Page 6: Remote Controls
REMOTE CONTROLS Power on / off: Power to the unit Adjust the flame color. Flame color can be adjusted according to the touch switch. 3&4. Adjust the flame brightness. Press 3 to decrease to flame brightness, press 4 to increase the flame brightness Heater setting. - Page 7 SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION Fireplace inner Reset switch by turning Fireplace components are master switch off and doesn't work. overheating or the home waiting for 5mins, then circuit breaker has tripped. turning it back on. Wiring may be loose or the Flame is not Call customer service for flame motor may be...
- Page 8 CLEANING Turn heater OFF and unplug from outlet. Use a vacuum or duster to keep heat and vent area clean from dust and dirt. The exterior of the stove should be cleaned with a damp cloth or duster. Do not use abrasive cleaners, liquid sprays, or any other cleaner that may scratch the surface.