Table of Contents
Advertisement
EventSpot 1600 Q4 Set
Before your initial start-up, please make sure that there is no damage caused by transportation. Should
there be any, consult your dealer and do not use the device.
To maintain perfect condition and to ensure a safe operation, it is absolutely necessary for the user to
follow the safety instructions and warning notes written in this manual.
Please consider that damages caused by manual modifications to the device are not subject to
warranty.
This device contains no user-serviceable parts. Refer servicing to qualified technicians only.
IMPORTANT:
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the device.
●
Never attempt lifting the device on your own. The device is heavy (63 kg). Use the included wheels
to move the device on flat surfaces. When lifting, ask at least 2 persons for assistance. Refer to the
regulations concerning safe manual handling of heavy objects.
●
Never remove warning or informative labels from the unit.
●
Never use anything to cover the ground contact.
●
Never place any material over the lens.
●
Never look directly into the light source.
●
Never leave any cables lying around.
●
Do not insert objects into air vents.
●
Do not connect this device to a dimmer pack.
●
Do not charge the battery in a closed case or container.
●
Do not switch the device on and off in short intervals, as this would reduce the device's lifespan.
●
Do not touch the device's housing bare-handed during its operation. Allow the fixture to cool for at
least 5 minutes before handling.
●
Do not shake the device. Avoid brute force when installing or operating the device.
●
Only operate the fixture after having checked that the housing is firmly closed and all screws are
tightly fastened.
●
Only operate the device after having familiarized with its functions.
●
Only use device in well-ventilated rooms.
●
Avoid flames and do not put close to flammable liquids or gases.
●
Always allow free air space of at least 50 cm around the device for ventilation.
●
Always disconnect the charging case from power before cleaning or replacing the fuse.
●
Make sure that the device is not exposed to extreme heat, moisture or dust.
●
Make sure that the available voltage is not higher than stated on the rear panel.
●
If the lens is obviously damaged, it has to be replaced to prevent its functions from being impaired,
due to cracks or deep scratches.
●
If device was dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
●
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your device. Leave the
device switched off until it has reached room temperature.
●
If your Showtec device fails to work properly, discontinue use immediately. Pack the unit securely
(preferably in the original packing material), and return it to your Showtec dealer for service.
●
For adult use only. Device must be installed out of reach of children. Never leave the unit running
unattended.
●
Never attempt to bypass the thermostatic switch or fuses.
●
For replacement, use fuses of same type and rating only.
Ordercode: 44057
4
Advertisement
Table of Contents
