Master/Slave; Settings - SHOWTEC EventSpot 1600 Q4 Set Manual

EventSpot 1600 Q4 Set
frequency.
10) If you have chosen PROGRAM SPEED, press the SET button to open the submenu.
11) Press the UP/DOWN buttons to set the desired program speed. The adjustment range is between 1–
100, from slow to fast.
12) If you have chosen STROBE, press the SET button to open the submenu.
13) Press the UP/DOWN buttons to set the desired strobe frequency. The adjustment range is between 0–
99, from OFF to high strobe frequency.

5. Master/slave

In this menu you can set the device as a slave.
01) In main menu, press the UP/DOWN buttons until the display shows Slave.
02) Press the SET button to open the menu. The display will show:
03) If you choose Yes, the device will become a slave. If the device has been set to slave, it will react
the same as its master device.
04) If you choose No, it will become a master device.
05) Press the SET button to confirm your choice.

6. Settings

In this menu you can set the device's settings.
01) In main menu, press the UP/DOWN buttons until the display shows Settings.
02) Press the SET button to open the menu. The display will show:
03) Press the UP/DOWN buttons to scroll through the following menus: Curves Select, Dimmer Speed, DMX
Fail, Working Time, DMX Sync, Lock, Calibration and Factory.
Ordercode: 44057
22