Replacement; Figure 2-8 Sbus Card Rear Panel With Adapter - Sun Microsystems SPARCcenter 2000 Manual

2

2.5.2 Replacement

2.5.2.1 Preparing a New SBus Card
2-8
1. Remove the black plastic card retainer shipped with the card.
Refer to Figure 2-7. Spread the ends of the retainer apart to remove it from
the card. The retainer is not needed for this installation.
Figure 2-7 SBus Card Retainer
2. Remove the adapter bracket from the SBus card rear panel.
Refer to Figure 2-8. Using a #0 Phillips screwdriver, remove two screws
securing the adapter to the card rear panel. The adapter bracket and screws
are not needed for this installation.
Card retainer
Adapter
Figure 2-8 SBus Card Rear Panel with Adapter
SPARCcenter 2000 System Board Manual—October 1994
Card retainer