Openboot Proms; Figure 2-16 Nvsimm Jumper Locations - Sun Microsystems SPARCcenter 2000 Manual

2
Battery
1

2.7 OpenBoot PROMs

2-16
34 35

Figure 2-16 NVSIMM Jumper Locations

5. Guide the SIMM into the slot so that the SIMM connector pads touch the
bottom of the socket.
The bottom alignment notch on the SIMM must align with the tab in the
center of the socket. The locking pins (refer to Figure 2-14) must align with
the holes in the sides of the SIMM.
6. Tilt the SIMM upright to lock it in place.
The locking tabs should automatically lock around the SIMM.
Note – The SIMM should require very little insertion force. If there are
difficulties, or if the SIMM does not resemble the original SIMM, the
replacement SIMM may be backward; check again that the alignment holes and
the alignment notch align exactly with corresponding parts of the SIMM socket.
7. Lock back into place any SIMMs that were loosened in the SIMM
removal steps.
Refer to Figure 2-17 for the PROM socket locations.
SPARCcenter 2000 System Board Manual—October 1994
Battery ON
Battery OFF
Jumper
68