Removal; Figure 2-4 Supersparc Modules A And B - Sun Microsystems SPARCcenter 2000 Manual

Figure 2-4

2.4.1 Removal

Warning – The heatsinks on the SuperSPARC modules may be hot. Use
caution when removing or installing SuperSPARC modules and avoid contact
with the heatsinks. Hold SuperSPARC modules only by the edges.
1. Unlock the four standoffs that secure the module to the system board.
Pull up the tip of a standoff to unlock it. Refer to Figure 2-3.
2. Hold the module by the edges near the connector and carefully rock the
module back and forth to loosen the connector from the socket.
Caution – The connector housing may break if the module is tilted too far.
!
3. Place the module in an antistatic bag.
2.4.2 Installation or Replacement
1. Unlock the four standoffs for this slot if they are not already unlocked.
Pull up the tip of a standoff to unlock it, as shown in Figure 2-3.
2. Take the SuperSPARC module out of the protective packaging, and
inspect the connector for bent pins.
Removing and Replacing System Boards and Assemblies
Super Super
SPARC SPARC
module module
A B
SuperSPARC Modules A and B
2
2-5