Figure 2-2 System Board Ejector/Injector Levers In The Unlocked Position; Using Standoffs - Sun Microsystems SPARCcenter 2000 Manual

Ejector/injector lever
Ejector/injector lever

2.3 Using Standoffs

4. Simultaneously, pull the curved ends of both ejector/injector levers
outward to release the board from the backplane connectors.
Refer to Figure 2-2.
5. Holding the board by both ejector/injector levers, gently slide the board
out of the card cage.
6. Place the board on a cushioned ESD mat or in an antistatic bag.
Figure 2-2 System Board Ejector/injector Levers in the Unlocked Position
Standoffs support and secure the SuperSPARC modules and SBus cards to the
system board.
•
To unlock a standoff, pull up the tip. Refer to Figure 2-3.
•
To lock a standoff, first ensure that the module or card rests on the standoff
flange, then press down the tip.
Removing and Replacing System Boards and Assemblies
2
2-3