Table of Contents
Advertisement
Initial setup for VMware and AWS deployments
Completing the first-login configuration
About this task
The first time you access a newly deployed EC2, you must complete a one-time system procedure
to accept the license agreement, configure the OS, and select network preferences.
Before you begin
Access the EC2 instance by logging in using PuTTY or SSH from the command line. Use the
®
Avaya Aura
Web Gateway administrator credentials and the EC2 DNS or IP address for the first
log in as follows:
<admin_name>@<instance_dns_or_ip_address>
For example:
ammapp@ec2-198-51-100-1.compute-1.internal
or
ammapp@198.51.100.1
Procedure
1. Do the following when you see the license agreement banner, which is displayed when you
log in for the first time:
a. Press Enter to display the license agreement.
b. Press the Space bar to navigate through the license agreement.
c. When prompted, type yes to accept the license agreement.
2. Enter a password for the system administrator.
3. To configure the NTP servers, do one of the following:
• Press Enter to accept the default Amazon NTP time servers.
• Enter one or more comma separated NTP server IP addresses or FQDNs and then
press Enter.
Important:
The NTP servers that you configure must be reachable from this server. The default
Amazon NTP time serves are on the Internet and might not be reachable.
4. Select your time zone preferences.
5. Review the summary of your selections and type one of the following:
• y to apply the settings to the system.
• n to make changes to your selections.
Next steps
Install the Avaya Aura
described in
Installing the Avaya Aura Web Gateway
October 2018
®
Web Gateway application software using the app install command as
Deploying the Avaya Aura
Comments on this document? infodev@avaya.com
on page 64.
®
Web Gateway
62
Advertisement
Table of Contents
