Faq - HDL BUSPRO SB-DN-HVAC User Manual

7. FAQ

7.1 MAC01.331FAQ001_HDL-BUS
Q:
In HDL-BUS Pro Setup Tool, I found a selection, Old or New, in DLP AC page.
A:
For 3-fan-speed-2-mode version, select "Old", for 3-mode-2-fan-speed version or
MAC01.331, select "New".
7.2 MAC01.331FAQ002_HDL-BUS
Q:
Apart from the relay totality is different from that of SB-DN-HVAC, I can see the
MAC01.331 has terminal for digital temperature sensor.
A:
Yes, the MAC01.331 has terminal for digital temperature sensor DS18B20, and has
built-in control logic, which means once a desired temperature is set (via user panel, e.g.,
a DLP panel) to it, it can regulate itself and control the room temperature. This is not true
for SB-DN-HAVC, the SB-DN-HAVC requires a DLP panel to be online always, because
the SB-DN-HVAC has no built-in the control logic, the control logic is in DLP panel
7.3 MAC01.331FAQ003_HDL-BUS
Q:
To control the FCU, I can use the SB-DN-HVAC or HDL-MAC01.331, but I can also use IR
(Infrared) to control it, which one is better?
A:
When IR control is possible, we always recommend customers to use IR (SB-IR-EM,
SB-CMS-12in1 or SB-CMS-8in1) to control the FCU, because to wire the proprietary HAVC system
rd
with 3 party controller (SB-DN-HVAC/HDL-MAC01.331), first, you may lose FCU warranty, even if
you have consulted and know that you won't lose FCU warranty, you are likely to lose some
features, like, Defrost, maybe. And second, to wire the two systems (HDL-BUS system and HVAC
system) together, you will have to spend some time to check the FCU manual carefully and are
required some knowledge about electrical diagram. More info, HDL has a module called
SB-DN-RS232N, this module can communicate
7.4 MAC01.331FAQ004_HDL-BUS
Q:
There are fan speed relays and there is 0-10V for fan speeds, which one to use?
A:
It depends on the FCU, you can refer to your FCU manual, some FCU fan speed is
controlled by relays, while other FCU fan speed is controlled by 0-10V.
AC controller – User Manual
User Manual
SB-DN-MAC01.331
16