Table of Contents
Advertisement
User Manual
SB-DN-MAC01.331
floor, this function allows you to monitor the status of the DLP air-condition function page
in the kid's room without going to
there.
Steps:
a) Select slave No. and tick on "Enable"
b) Fill in the slave DLP panel's subnet/device ID and save.
c) Finally save the changes.
6.2.4.4 Synchronous control
This function is DLP to DLP data transferring and sharing method, several DLPs can
share the setup information each other DLP when using IR emission function to control
HVAC on DLP, Up to 8 DLPs can be connected synchronously.
to set up synchronous controlling between several DLP's
Steps:
a) ON DLP air-conditioning function tab, select synchronous control
b) Select AC NO.
c) Tick on enable to activate the synchronous function
d) Fill in the subnet/subnet ID of the target DLP
e) Enable the IR emission function
f) All above steps must be done on each DLP respectively
6.2.4.5 Other functions
1) Setup
There are many useful settings in this section such as :-
a) Temperature model:
select C or F
b) Air-condition information:
you can select or deselect some of the function according to
the end-user requirements and needs.
c) Set power saving:
If this option is selected the fan will switch off automatically when the
desired (target) temperature is reached.
AC controller – User Manual
13
Advertisement
Table of Contents
