Allen-Bradley PowerFlex 700H Hardware Service Manual page 70

3-34 Access Procedures
8. Loosen, but do not remove, the screws that secure the Y Bus Bars to the
drive.
Y Bus Bars
9. Remove the balancing resistor wires from bus bars.
AC Input
Terminals
(L1, L2, L3)
10. Disconnect all wiring from the circuit board on the Rectifying Module.
11. Disconnect the cables from the AC input terminals on the Rectifying
Module.
12. Remove the circuit board from the Rectifying Module (refer to
Removing the Rectifying Boards on page
Balancing Resistors
Balancing Resistor Wires
3-29).