Allen-Bradley PowerFlex 700H Hardware Service Manual page 67

7. Remove the balancing resistor wires from bus bars.
Balancing Resistors
Balancing Resistor Wires
Snubber Capacitors
Snubber Capacitor
Fastening Screws
8. Remove the screws that secure the Snubber Capacitors, and remove the
Snubber Capacitors.
9. Remove the screws that secure the DC Bus Bars to the left side of the
power structure, and remove the DC Bus Bars.
10. Remove the screws which secure the Output Power Module to the drive.
11. Disconnect the Power Module Circuit Board from the Adapter Board.
Access Procedures 3-31