Allen-Bradley PowerFlex 700H Hardware Service Manual page 44

3-8 Access Procedures
Removing the 700S High
Power Fiber Optic Interface
Circuit Board
6. Loosen the two mounting screws on the front of the Control Assembly
and slide the control cassette off the mounting bracket.
Installation
Install the 700S Phase II Control Assembly in reverse order of removal,
while referring to Torque Specifications on page
Removal
1. Remove power from the drive
page 3-3).
2. Remove the 700S Control Assembly
Control Assembly on page
3. Carefully disconnect the fiber-optic cables from the sockets along the
right side of the High Power Fiber Optic Interface Circuit Board (on the
backside of the Control Assembly), and carefully set them aside.
ATTENTION: Hazard of permanent eye damage exists when
!
using optical transmission equipment. This product emits intense
light and invisible radiation. Do not look into fiber-optic ports or
fiber-optic cable connectors.
Note: Ribbon cables not shown
for clarity only.
3-1.
(Removing Power from the Drive on
(Removing the 700S Phase II
3-6).