Safety Instructions For Installation - Miele SmartLine CS 7101 Operating And Installation Instructions

Fit the wall units and cooker hood before fitting the SmartLine element to avoid
damaging it.

The room in which the SmartLine element is installed must con-
form to all relevant local and national building regulations and safety
regulations.
In the UK: GasSafe regulations

The veneer or laminate coatings of worktops (or adjacent kitchen
units) must be treated with 100 °C heat-resistant adhesive which will
not dissolve or distort. Any backmoulds must be of heat-resistant
material.

A deep fat fryer must not be installed directly next to a gas hob or
a wok burner as the gas flames could ignite the fat in the fryer. It is
essential to maintain a distance of at least 288 mm between these
two appliances.

The SmartLine element must not be installed over a fridge, fridge-
freezer, freezer, dishwasher, washing machine, washer-dryer or
tumble dryer.

When installing the SmartLine element, make sure that the gas
pipe and mains connection cable cannot come into contact with hot
appliance parts.

The mains connection cable and any flexible gas connection pipes
must be installed in such a way so that they do not come into con-
tact with any moving kitchen parts (e.g. a drawer) after the SmartLine
element has been installed, and that they cannot be subjected to any
mechanical action which could cause damage.

Observe carefully the safety clearances listed on the following
pages.

Safety instructions for installation

35