Fitting Of The Dahl Lock Plate On Wheelchair - Paravan PR Heavy Duty User Manual

15.6.2

Fitting of the Dahl lock plate on wheelchair

In order to fit the Dahl Lock plate an additional wheelchair specific
adaptation kit is required. It contains special nut and plastic spacers,
which are to be fitted inside the battery box.
① Angle plate for Dahl system (PV-Art. Nr: 000033185)
② Side mounting for Dahl system (PV-Art. Nr: 000034091)
③ 8 mm intermediate piece for locking plate 10069 DAHL
(PV-Art. Nr: 000010131)
④ Locking rail for Dahl-System (PV-Art. Nr: 000033184)
⑤ Oval-head screw ISO 7380 - M8 x 12
⑥ Socket cap screw DIN 912 - M12 X 20
⑦ Countersunk screw TORX ISO 14581 - M8 x 35 -14.9
⑧ Hexagon nut ISO 4032 - M8
› To install the Dahl Locking plate use PARAVAN Adaption kit, article
number 33187
To assemble the adapter set of the Dahl docking station, you need
›
two Allen keys, size 5 and size 10, a Torx 27 and a wrench SW 13.
Tighten the Torx screws to a torque of 16-18 Nm.
›
The panelling must first be removed in order to mount the Dahl
›
docking station to the Paravan wheelchair.
78
Fig. 39: Paravan Kit for Dahl docking station
Fig. 40: Torx 27
Loading and transporting your electric wheelchair
To remove the cover, loosen all four knurled screws ①.
›
Remove the rear panel ② first, then the side panels ③.
›
Disconnect the main cable plug from the batteries left and right ④.
›
④
Fig. 42: Main Cable battery Fig. 43: Disconnect battery
Loading and transporting your electric wheelchair
①
Fig. 41: Knurled screws Paravan
③
④
Fig. 44: Rear and side panels Paravan
②
79