Figure 26: Correct filtering
Confirming port belongs to at least one VLAN
View information to ensure that the port belongs to a VLAN.
1. Use the show vlan interface info <port> command to view the details.
2. Note the VLANs listed with the port.
Disabling the VLAN filtering of unregistered frames
Change the unregistered frames filtering of the VLAN.
1. Use the vlan ports <port> filter-unregistered-frames enable
2. Ensure no errors after command execution.
Reload ADAC MAC in range table
Ensure the ADAC MAC address is properly loaded in the range table.
Troubleshooting 5.1
command to view the details.
IP phone is not detected
February 2013
73