Avaya 3500 Series Troubleshooting Manual page 74

Troubleshooting ADAC
Task flow Reload ADAC MAC in range table
The following task flow assists you to place the ADAC MAC address in the range table.
Figure 27: Reload ADAC MAC in range table
Disconnecting and reconnecting phone
Remove the phone and the reconnect it to force a reload of the MAC address in the range
table.
1. Follow local procedures to disconnect the phone.
2. Follow local procedures to reconnect the phone.
Disabling and enabling the port
Disable ADAC on the port and then enable it to detect the phone. When disable and reenable
the port administratively, the MAC addresses already learned on the respective port are aged
out.
1. Use the no adac enable <port> command to disable ADAC.
2. Use the adac enable <port>command to enable ADAC.
74 Troubleshooting 5.1
Comments? infodev@avaya.com
February 2013