HIKVISION DS-7208HTI-K2 User Manual page 3

DS-720xHTI-Kx DVR User Manual
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-3 (A)/NMB-3(A) standards requirements.
Symbol Description
Provides additional information to emphasize or supplement important points of the main text.
Indicates a potentially hazardous situation, which if not avoided, could result in equipment damage, data loss, performance
degradation, or unexpected results.
Indicates a hazard with a high level of risk, which if not avoided will result in death or serious injury.
Symbol Conventions: The symbols that may be found in this document are defined as follows:
Safety Instructions
Proper configuration of all passwords and other security settings is the responsibility of the installer and/or end-user.
In the use of the product, you must be in strict compliance with the electrical safety regulations of the nation and region. Refer to
technical specifications for detailed information.
Input voltage should meet both the SELV (Safety Extra Low Voltage) and the Limited Power Source with 100 to 240 VAC, 12 VDC, or 48 VDC
according to the IEC60950-1 standard. Refer to technical specifications for detailed information.
Do not connect several devices to one power adapter as adapter overload may cause over-heating or a fire hazard.
Make sure that the plug is firmly connected to the power socket.
If smoke, odor, or noise rise from the device, turn off the power at once and unplug the power cable, and then contact the service center.
Preventive and Cautionary Tips
Before connecting and operating your device, be advised of the following tips:
Ensure unit is installed in a well-ventilated, dust-free environment.
Unit is designed for indoor use only.
Keep all liquids away from the device.
Ensure environmental conditions meet factory specifications.
Ensure unit is properly secured to a rack or shelf. Major shocks or jolts to the unit as a result of dropping it may cause damage to the
sensitive electronics within the unit.
Use the device in conjunction with an UPS if possible.
Power down the unit before connecting and disconnecting accessories and peripherals.
Use only a factory recommended HDD for this device.
Improper use or replacement of the battery may result in hazard of explosion. Replace with the same or equivalent type only. Dispose of
used batteries according to the instructions provided by the battery manufacturer.
Mandatory Electrical Requirements
Hikvision requires the following conditions and equipment for all of its electronic equipment:
Grounding
Ensure good conductivity for all ground paths; examine ground path contact surfaces for defects, dirt, corrosion, or non-conductive
coatings that may impede conductivity. Repair or clean contact surfaces as necessary to assure good metal-to-metal contact. Ensure
fasteners are properly installed and tightened.
Electrical Wiring
Ensure your outlets are properly wired. They can be checked with an electrical outlet tester.
Surge Suppressor (Required)
Hikvision is not responsible for any damage to equipment caused by power spikes in the electrical power grid. Use of a surge suppressor
meeting the following specifications is mandatory for all Hikvision electronic equipment:
Specifications
Listed by Underwriter's Laboratories, meeting the UL 1449 Voltage Protection Rating (VPR)
Minimum protection of 1,000 joules or higher
Clamping voltage of 400 V or less
Response time of 1 nanosecond or less
Usage
Surge suppressors must not be daisy chained with power strips or other surge suppressors
UM DS-720xHTI-Kx 012918NA 2