Display "Gyro Setting - GRAUPNER Falcon 12 Manual

FREE MIXER
MIXER
FROM CHANNEL:
TO CHANNEL:
TRIM:
TRAVEL–: +100%
TRAVEL+: +100%

Display "Gyro setting"

Gyro setting
MODE AI/EL
MODE RU
Aile:
Elev:
Rudd:
Factor:
S1019_S1034_S1035_33579_33583_FW2_DE_V1.0sh
Butterfly mixer with elevator addition
FREE MIXER
1 MIXER
1 FROM CHANNEL:
2 TO CHANNEL:
+0% TRIM:
TRAVEL–:
TRAVEL+:
Notes
• These mixers may only be needed on transmitters without trans-
mitter-side butterfly mixers.
• The respective travel setting must be adapted to the model and
made so that the servos never stall mechanically.
Preparation step-by-step
1. With deactivated gyroscope, carefully trim the model on one or
more trim flights on the transmitter side.
2. Switch the receiver off and on again to transfer the flown trim
state to the memory of the receiver.
3. Enable gyro control as described below.
4. Set the factor for gyro correction, eventually check the values for
the single control surfaces.
MODE
The mode can be set separately for AILE/ELEV and RUDD.
0
The mode can be set permanently or it can be switched through an
0
assignable control channel. If a proportional control is assigned to
5
the selected control channel in the transmitter, the respective mode
5
5
can be activated in the following setting ranges of the maximum pos-
OFF
sible servo travel:
Mode
0 (no regulation)
1 (normal regulation)
2 (Heading Lock mode with suppress.)
(In stick center position Heading-Lock
acts. Outside the stick neutral position
the gyro control is active.)
3 (Rate mode)
(In the stick neutral position Hea-
ding-Lock acts over the entire control
area)
FREE MIXER
2 MIXER
1 FROM CHANNEL:
5 TO CHANNEL:
+0% TRIM:
+100% TRAVEL–:
+100% TRAVEL+:
–150 % ... –75 %
+25 % ... +150 %
3
1
3
+0%
+10%
+10%
Range
–75 % ... –25%
–25 % ... +25 %
23 / 52