GRAUPNER Falcon 12 Manual page 27

S1019_S1034_S1035_33579_33583_FW2_DE_V1.0sh
• In the transmitter, the setting of the direction of rotation for
both aileron servos must always be identical. So either both nor-
mal or both reverse! If this is not possible, the relevant servo
must be installed in the model turned accordingly!
• Are used programmable servos, for example Graupner DES, HVS
or HBS servos, the servo reverse setting can be made directly in
the servo according to the corresponding instructions.
• Observe the instructions for receiver installation further in this
manual!
• If required, the axes can be manually reset to "+0" (= gyro inac-
tive). Do not manually set any other value unless you know
exactly what you are doing.
Do setup
After selecting the line "do setup" and changing the value field to
"yes", assign the axes as follows:
Do setup step by step
1. Select line press or tap the ENT key.
"NO" is displayed inverted.
2. Change the value field to "YES".
3. Push or tap on the ENT key.
4. At the transmitter, move the aileron control stick in the right hand
direction at least 25% of the control way.
The display shows the "Aileron" inverted.
5. Tilt the model more than 45 degrees to the right.
As soon as the detected axis with the sign axis number is dis-
played in "normal" representation, the axis assignation is com-
pleted.
ശ The number results from the addressed gyro axis and the sign
from installation position of the receiver and servo direction
of rotation.
6. At the transmitter, move the elevator control stick forward at
least 25% of the control way.
The display shows the "Elevator" inverted.
7. Tilt the model more than 45 degrees to the front.
As soon as the detected axis with the sign axis number is dis-
played in "normal" representation, the axis assignation is com-
pleted.
8. At the transmitter, move the rudder control stick in the right hand
direction at least 25% of the control way.
The display shows the "Rudder" inverted.
27 / 52