Table of Contents
Advertisement
30
Connect Devices
Pos : 75 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/Ansc hließ en/Ger äte ansc hließen - Ü bers chrift 1 @ 3\mod_1234172889468_21.doc x @ 27460 @ 1 @ 1
6
Connect Devices
Pos : 76 /All e Seri en (Allgemei ne Module)/Wic htige Erläuterungen/Sicherheits- und s ons tige Hi nweis e/Gefahr/Gefahr: Lei tungen nur i n s pannungsfr eiem Zus tand ansc hliessen oder trennen @ 16\mod_1372153982130_21.doc x @ 124277 @ @ 1
Only connect or disconnect lines when power is safely isolated!
The lines to the device can carry hazardous voltages and currents. Contact with
the lines when live can result in severe injury or death. Therefore, read and
observe the following safety rules before you perform work on the device:
1.
Disconnect the respective system component from the power supply.
2.
Secure the system component against unintentional restart.
3.
Check if the voltage is positively isolated.
Pos : 77 /Serie 750 ( WAGO-I/O-SYST EM)/Ans chli eßen/Leiter an C AGE C LAM P ans chli eßen ( allgemei n) - Übersc hrift 2 und Text @ 3\mod_1225448660171_21.doc x @ 24928 @ 2 @ 1
6.1
Connecting a Conductor to the CAGE CLAMP
The WAGO CAGE CLAMP
finely stranded conductors.
Only connect one conductor to each CAGE CLAMP
Only one conductor may be connected to each CAGE CLAMP
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-
through terminals.
Exception:
If it is unavoidable to jointly connect 2 conductors, then you must use a ferrule to
join the wires together. The following ferrules can be used:
Length:
Nominal cross section
WAGO product:
1.
For opening the CAGE CLAMP
above the connection.
2.
Insert the conductor into the corresponding connection opening.
3.
For closing the CAGE CLAMP
now clamped firmly in place.
750-517 2DO 230V AC 1.0A/ Relay 2CO/ Potential Free
®
connection is appropriate for solid, stranded and
8 mm
2
:
1 mm
for 2 conductors with 0.5 mm
max.
216-103 or products with comparable properties
®
insert the actuating tool into the opening
®
simply remove the tool. The conductor is
WAGO-I/O-SYSTEM 750
®
®
!
®
.
2
each
Manual
Version 1.1.2
Advertisement
Chapters
Table of Contents
