Table of Contents
Advertisement
Modem Dialout Setup
Dialout
Call Type
Micromon
Sampling Rate
The Sampling Rate affects the amount of data that will be stored in the units
memory.
S
o t
S
a
m
l p
n i
g
R
0
8
0
Z
8
1
6
4
8 (
0
8
0
Z
8
1
6
5
1 (
Use this option to select the modem dialout settings. From the Extended Menu,
select Modem Dialout Setup.
When connected to a modem, the Micromon is able to make telephone calls to up
to five pre-programmed numbers whenever an alarm is detected (see Alarm
Actions section). Alternatively, individual alarms detected for a particular point can
be routed to a particular telephone number. It can also call a radio pager to alert a
duty engineer. Three types of pager can be supported - Tone only, Numeric and
Alphanumeric. The message that is sent can also be defined.
Note: Support for the TAP pager protocol may vary from country to country.
Use the '
' or '
fields for each device as described below:
Use this field to specify the type of device which is connected to the specified
telephone number. The options are as follows:
NO DIAL
GSM SMS
For information on this feature refer to document Functional
Description RC.8A.M.
DOWNLOAD Indicates that a computer is connected (directly or remotely)
Parity, 1 Stop Bit).
AKM
(refer to appendix A).
BEEPER
As there is no security associated with this option, the telephone
number is always dialled twice unless the busy tone is received.
MESSAGE7 Indicates that a 7 bit modem is connected with a printer
MESSAGE8 Indicates that a 8 bit modem is connected with a printer
RS.8A.Y3.02
Micromon
set as Timed or ON will be included.)
Set this field to the frequency of sampling
graphs. The most commonly used value is 15 mins.
a r
g
e
P
r e
o i
d
n i
M
o
a
e t
(
M
n i
) s
1
3
p
o
n i
) t
1
7 .
5
2 .
6
p
o
n i
) t
1
3
' keys to scroll through the dialout numbers and complete the
Indicates the Micromon will not dialout.
Indicates that a RS232/GSM modem device is connected. Sends
text messages to a GSM mobile phone and receives messages.
running Danfoss Central Station software. If the line is busy,
the telephone number will be dialled up to four times (8 bit, No
Indicates that a computer is connected (directly or remotely)
running Danfoss 'AKM' software. If remotely, dialout attempts will
continue and after every 10 attempts the alarm relay will reset the
modem.
Note: Modem must be wired in conjunction with the alarm relay
Indicates that a beeper type pager is connected. The system
dials the appropriate telephone number and then disconnects.
(7 bit, Even Parity, 1 Stop Bit) (normally used in France).
(8 bit, No Parity, 1 Stop Bit) (normally used in UK).
© Danfoss 01-2003
required for the
n
h t
s
1
0
1
5
1
7
3 .
2
5
8 .
1
0
1
4
9 .
attached.
attached.
11
- Quick Links:
- Alarm Action
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Micromon and is the answer not in the manual?
Questions and answers