Designated Use; Transportation, Storage - SEW-Eurodrive MOVIMOT D EtherNet/IP Compact Manual

2 Safety notes

Designated use

2.4 Designated use
2.4.1 Safety functions
2.4.2 Hoist applications
2.5

Transportation, storage

8
Compact Manual – EtherNet/IP™ Interfaces, Field Distributors
Field distributors and fieldbus interfaces are components intended for installation in
electrical systems or machines.
In case of installation in machines, startup of the field distributors and fieldbus inter-
faces (i.e. start of designated operation) is prohibited until it is determined that the ma-
chine meets the requirements stipulated in the Machinery Directive 2006/42/EC.
Startup (i.e. the start of designated use) is only permitted under observance of EMC
Directive 2004/108/EC.
The field distributors and fieldbus interfaces meet the requirements stipulated in Low
Voltage Directive 2006/95/EC. The standards listed in the declaration of conformity
are applied to the field distributors and fieldbus interfaces.
Technical data and information on the connection requirements are provided on the
nameplate and in the documentation; these must be observed under all circum-
stances.
Field distributors, fieldbus interfaces and MOVIMOT
functions unless these functions are described and expressly permitted.
®
If MOVIMOT inverters are used in safety applications, the supplementary documenta-
®
tion "MOVIMOT MM..D – Functional Safety" must be observed. Use only those com-
ponents in safety applications that were explicitly designed and delivered for this pur-
pose by SEW‑EURODRIVE.
®
When using MOVIMOT
configuration and settings for lifting applications specified in the operating instructions
®
for MOVIMOT .
®
Do not use MOVIMOT inverters as safety devices in lifting applications.
You must observe the notes on transportation, storage and proper handling. Comply
with the requirements for climatic conditions stated in chapter "Technical data" of the
manual. Tighten installed eyebolts securely. They are designed to handle the weight
®
of the MOVIMOT drive. Do not attach any additional loads. Use suitable, sufficiently
rated handling equipment (e.g. rope guides) if required.
inverters in lifting applications, you must observe the special
®
inverters may not perform safety