Entering Process Data Via The Cmd Software - Festo IFB21-03 Electronic Manual

4. Commissioning
1
Standard mode
2
Siemens mode
3
8-input module
4
4-input module
Fig. 4/10: Address assignment of the inputs with Siemens controllers and other con-
trollers on the INTERBUS

4.2.5 Entering process data via the CMD software

4-30
Example: address assignment of the inputs
4
The CMD software offers, as from version 4, the possibility of
assigning each input/output of a valve terminal within the
configured address range to any input/output in the PLC/IPC.
To do this, proceed as follows:
S
Add a valve terminal to your bus structure (necessary
steps see section 4.2.2 "Configuring the bus with CMD
software").
1
2
3
Festo P.BE-VIFB21-03-EN en 0010a