Hitching And Unhitching; Hitching; Lift Arm Tilt Angle; Mounting Behind Tractor - DAL-BO Frontflex 2000 Series Manual

The Frontflex 2000 is manufactured in compliance with DS/ISO 730-1 cate-
gory II. The arms of the front lift must be rigid, preventing them from moving
sideways. If the front lift of your tractor is not suitable, please contact your
Dal-bo distributor.

Hitching

Mount the lift arms into the hitch points (A, Fig. 1). Next, install the top link.
Adjust the top link so that the main frame of the Frontflex is in a horizontal
position and parallel to the ground. Raise the implement, allowing the parking
stands (front and rear) to clear the ground and placing the implement in an
operating position.
Ñ
Fig. 1

Lift arm tilt angle

With the Frontflex in an operating position, the lift arms (B) should be tilted
at an angle preferably a couple of degrees above horizontal of the direction of
travel or at least horizontal. This angle will enable the Frontflex to roll over
any obstacles, as the tractor presses the implement tilted upwards and the
steering will be simultaneously maintained. (Steering can be made even easier
if the top link is shortened, so that the main frame points a few degrees up-
wards in the front.)

Mounting behind tractor

The Frontflex can be mounted in the three-point hitch on the rear of the tractor
if needed.
side 6

Hitching and Unhitching

Remember to secure the lift arms and top link with lynch pins.
B
A
Frontflex 2000