Fluke 6055 User Manual page 52

Interface command summary cont.
Command Description
Set cut-out to be reset
automatically
Read Stirrer Mode
Set Stirrer Mode:
Set stirrer activation
mode to on
Set stirrer activation
mode to auto
Read Stirrer Set-Point
Set Stirrer Set-Point to n
Serial Interface Menu
Read serial sample setting
Set serial sampling setting to n
seconds
Set serial duplex mode:
Set serial duplex mode to full
Set serial duplex mode to half
Set serial linefeed mode:
Set serial linefeed mode to on
Set serial linefeed mode to off
Calibration Menu
Read C0 calibration parameter
Set C0 calibration parameter to n *c0=n
Read CG calibration parameter
Set CG calibration parameter to n
Read low set-point limit value
Set low set-point limit to n
Read high set-point limit value
Set high set-point limit to n
Miscellaneous (not on menus)
Read firmware version number
Read structure of all commands
Read Heater 1
Set Heater 1
Command Command
Format Example
cm[ode]=a[uto] cm=a
smod smod
smod=o/a
smod=o smod=o
smod=a smode=a
sset sset
sset=n sset=160
sa[mple] sa
sa[mple]=n sa=0
du[plex]=f[ull]/h[alf]
du[plex]=f[ull] du=f
du[plex]=h[alf] du=h
lf[eed]=on/of[f]
lf[eed]=on lf=on
lf[eed]=of[f] lf=of
*c0 *c0
*c0=0
*cg *cg
*cg=n *cg=406.25
*tl[ow] *tl
*tl[ow]=n *tl=-80
*th[igh] *th
*th[igh]=n *th=205
*ver[sion] *ver
h[elp] h
f1 f1
f1=1/0
9 Digital communication interface
Returned
Returned Example
smod: {xxxx} smod: AUTO
sset: 9999.99 {C or F} sset: 160.00C
sa: 9 sa: 1
c0: 9 c0: 0
cg: 999.99 cg: 406.25
tl: 999 tl: –80
th: 999 th: 205
ver.9999,9.99 ver.2100,3.56
list of commands
f1:9 f1:1
Interface commands
Acceptable
Values
ON or AUTO
instrument
range
0 to 4000
FULL or HALF
ON or OFF
–999.9 to 999.9
–999.9 to 999.9
–999.9 to 999.9
–999.9 to 999.9
1 or 0
49