Day Part Setting (Submode 46) - TEC FS-2600-1 SERIES Owner's Manual

5. PROGRAMMING OPERATIONS

Day Part Setting (Submode 46)

A maximum of 6 day parts can be set. You can obtain major group sales data by each day part.
CONDITION After Day Part Reset
OPERATION Mode Lock: SET
46 [X] |Hour| |Minute| [#]
Enter the time that ends
each day part, in the 24-
hour system.
Repeat until all the day parts are entered. (max. 6 day parts)
ex.) To set the following day part table.
Day Part 1: Up to 10:00*
Day Part 2: 10:01 to 14:00
Day Part 3: 14:01 to 18:00
Day Part 4: 18:01 to 22:00
* (The first day part is automatically continued from 22:01 of the preceding day.)
Mode Lock: SET
Enter 46, depress [X].
1000 [#] 1400 [#] 1800 [#] 2200 [#] [AT/TL]
NOTES: 1. A maximum of 6 day parts can be set.
2. To change the table of day parts once set, partially or entirely, do the entire setting operation over
again.
2. To reset the day parts table once set, operate:
Mode Lock: SET
46 [X] 0 [#] [AT/TL]
Then no day part sales data will be outputted on the reports.
3. Do not set a day part across 24:00, such as "from 23:00 to 1:00". If set, no data will be processed
into that day part.
When you enter 46 and depress the [X] key,
the screen shown below will appear.
* SET * 02-06-1999 12:34
PROGRAMMING
01
02
03
04
05
06
Please input data.
Pg up
[AT/TL]
P46 DAY
5-48
5.4 How to Access a Program Item
DAY PART
0.00
Pg dw Enter
Journal Print
PART
10:00TM
14:00TM
18:00TM
22:00TM
0083 10:40TM
EO1-11138