Department Table Programming (Submode 3) - TEC FS-2600-1 SERIES Owner's Manual

5. PROGRAMMING OPERATIONS

Department Table Programming (Submode 3)

• Programming
CONDITION To change the Positive/Negative
Status:
To change any other programmed
data or to program new departments:
OPERATION Mode Lock: SET
3 [X]
Submode No.
Operation
procedure
surrounded
by this line
is the same
Repeat for any
as the
address within
operation in
the same dept.
Submode 4.
by re-entry for
correction.
(NOTE 2)
Repeat for
other
departments.
[ST]
[ST]
Executes DLL.
After Department Daily & GT
and PLU Daily & GT Reset
Any time outside a sale
As for details of each Address,
refer to the following pages.
|Address Nos| [#]
(NOTE 1 on the next page.)
Address 1: Link Group
1 [ST]
Address 2: Department Name
2 [ST]
Address 3: Status 1
3 [ST]
Address 4: Status 2
4 [ST]
Address 5: Tax Status
5 [ST]
Address 6: High Amount Limit
6 [ST]
Address 7: Low Amount Limit
7 [ST]
Address 8: Takeout Tax Status
8 [ST]
[AT/TL] (to complete this submode)
When you enter 3 and depress the [X] key,
the screen shown below will appear.
* SET * 02-06-1999 12:34
PROGRAMMING
01 DP01
02 DP02
03 DP03
04 DP04
05 DP05
06 DP06
07 DP07
08 DP08
Please input Department code.
Pg up Pg dw
(NOTE 2 on the next page.)
|Department Code|
for sequential-coded Dept. only
|Major GP| |Minor GP| [#]
(01 to 10)
Character Entries [ST]
max. 16 characters
|Status Code to ON| [#]
|Status Code to ON| [#]
|High Amount to be locked
|Low Amount to be locked
|Takeout Tax Code| [#]
5-11
5.4 How to Access a Program Item
DEPARTMENT
0.00
Enter
Barcode Scanning
[DP#]
(01 to 30)
|Tax Code| [#]
out| [#]
(max. 7 digits)
out| [#]
(max. 7 digits)
EO1-11138