How To Access A Program Item - TEC FS-2600-1 SERIES Owner's Manual

5. PROGRAMMING OPERATIONS
Thus the condition "After ... Reset" indicates that all the sales data relating to the report data must be zero
(except non-resettable memory data). Because of this "CONDITION" requirement, the report data will be
protected from any inconsistencies of sales data entered in the period from a resetting of the report to another
resetting of the same report next time.
5.4

How to Access a Program Item

Same as in the X or Z mode, two ways are available to access a program item; through the operator display and
through the keyboard.
5.4.1 How to Access a Program Item through the Operator Display
When you turn the mode selector key to the SET position, the initial screens shown below will appear.
* SET * 02-06-1999 03:04
1 PROGRAMMING
2 PROGRAM READ
3 PROGRAM DLL
Please select operation by Enter key.
Pg up Pg dw
Description of each Navigation Key
Display Item
1 Navigation Key 1
2 Navigation Key 2
3 Navigation Key 3
4 Navigation Key 4
5 Navigation Key 5
Example) If you want to perform the time setting or adjustment (submode 5), operate as follows.
0.00
TOTAL 0.00
Enter
13
14
15 1 2
••••*•••• ••••*•••• ••••*•••• ••••*•••• 10
Pg up Requests the preceding program menu screen.
Pg dw Requests the next program menu screen.
Enter Decides a selected item. Also decides an entered numeric value or
character.
Cursor Key
Cursor key
3 4 5
20 30
Description
5-5
EO1-11138
5.4 How to Access a Program Item
13
14
15
40