Printer Table Setting (Submode 71) - TEC FS-2600-1 SERIES Owner's Manual

5. PROGRAMMING OPERATIONS

Printer Table Setting (Submode 71)

This programming is used to set a printer table. You can set two printer tables.
CONDITION Any time outside a sale
OPERATION Mode Lock: SET
Address 1: Destination of Output (Printer Table 1)
71 [X] 1 [NS]
Address 2: Connection Status (Printer Table 1)
2 [NS]
Address 3: Destination of Output (Printer Table 2)
3 [NS]
Address 4: Connection Status (Printer Table 2)
4 [NS]
Address 5: Printer Model
5 [NS]
Address 6: Transmission Speed
6 [NS]
|Destination of Output| [ST]
When the multiple destinations are designated
|Destination of Output| [ST]
When the multiple destinations are designated
|Destination of Output| [ST]
When the multiple destinations are designated
|Destination of Output| [ST]
When the multiple destinations are designated
|Port No.| [ST]
When the multiple ports are designated
|Port No.| [ST]
When the multiple ports are designated
* Repeatable from here if each code is sequential.
5-56
5.4 How to Access a Program Item
When you enter 71 and depress the [X] key,
the screen shown below will appear.
* SET * 02-06-1999 12:34
PROGRAMMING PRINTER
01 OUTPUT SIDE1
02 SIDE1 STATUS
03 OUTPUT SIDE2
04 SIDE2 STATUS
05 CONNECT PRT
06 BAUD RATE
Please input item No.
Pg up Pg dw Enter
|Terminal ID/Port No.| [#]
*
|Connection Status| [#]
*
|Terminal ID/Port No.| [#]
*
|Connection Status| [#]
*
|Printer| [#]
*
|Transmission Speed| [#]
*
EO1-11138
0.00
[AT/TL]