TEC FS-2600-1 SERIES Owner's Manual page 192

3. PROGRAMMING OPERATIONS
3.2.2 Terminal ID Setting (Submode 77)
This submode is available for in-line terminals (including the master and backup master terminals) . It must be
operated separately on each terminal since the Terminal ID should vary from terminal to terminal. The data set in
this submode is used as the in-line address of the terminal for in-line service operations.
CONDITION Any time outside a sale
OPERATION Mode Lock: SET and RTR Declaration is ON (for the Master Terminal)
Mode Lock: SET (for other terminals)
(Use the SET Mode Keyboard Sheet after depressing the [RTR] key on the REG Mode
Keyboard Sheet.)
Through the Operator Display
Select "1 PROGRAMMING".
* SET * 02-06-1999 03:04
1 PROGRAMMING
2 PROGRAM READ
3 PROGRAM DLL
Please select operation by Enter key.
Pg up Pg dw
Through the Keyboard
77 [X] |Terminal ID No.|
1: Master
2: Backup Master
3 to 16: Satellites
ex.) To assign Terminal ID No. 4 to a satellite terminal of the in-line system:
Mode Lock: SET
77 [X] 4 [AT/TL]
NOTE: Be certain not to set the same terminal ID No. to terminals on the in-line system.
If terminals with the same ID No. exist on the in-line system, malfunction may occur.
RTR
0.00
TOTAL 0.00
Enter
3.2 Programming Operations Added for In-line Terminals
Select "77 INLINE ID".
* SET * 02-06-1999 03:04
PROGRAMMING
68 PC COMM
69 CONNECT REG
70 INLINE COMM
71 PRINTER
73 PRICE CHG
77 INLINE ID
78 LOGO
TAX TABLE
Please select operation by Enter key.
Pg up
[AT/TL]
12-25-1999
P77 INLINE
INLINE ID
3-4
T/M DESIGN
0.00
Pg dw Enter
Journal Print
SAT #3001
ID
0196 01:52TM
EO1-11138
04