Toshiba LF414 Instruction Manual page 32

Electromagnetic flowmeter detector
Hide thumbs

Advertisement

Table of Contents
Install a switch and fuse to isolate the
LF414/LF600F, LF610F and LF414 from
mains power.
Power supply from mains power can
cause electric shock or circuit
break-down.
DO
Do not work on piping and wiring with wet
hands.
Wet hands may result in electric
shock
DON'T
Do not conduct wiring work with bare hands.
Remaining electric charge even if
power is turned off can still cause
electric shock.
DON'T
Do not modify or disassemble the LF600F,
LF610F, LF602F and LF612F
unnecessarily.
Modifying or disassembling this
product can cause electric shock,
malfunction of or damage to this
DON'T
product.
Flowmeter accuracy may be affected by the way wiring is executed. Proceed with correct wiring taking
the precautions in following pages.
CAUTION
Turn off mains power before conducting wiring
work.
Wiring while power is applied can cause
electric shock.
DO
Ground the LF600F, LF610 independently from
power equipment. (100 ohm or less ground
resistance)
Operating this product without grounding
can cause electric shock or malfunction.
DO
For the power supply wiring and grounding wiring,
use crimping terminals with insulated sleeve.
There is a risk of electric shock due to
drop-off or loosing, and a risk of fire and
equipment trouble due to heat generation.
DO
The label shown left is placed near the
power supply terminal on the
converter.
Be alert to electric shock.
- 31 -
6F8A0870

Advertisement

Table of Contents
loading

  Also See for Toshiba LF414

  Related Manuals for Toshiba LF414