Suzuki Wagon R RB310 Supplementary Service Manual page 50

3) Disconnect ABS hydraulic unit/control module assembly con-
nector (1) by pulling up lock (2).
4) Using special tool, loosen flare nuts (1) and disconnect brake
pipes (2) from ABS hydraulic unit/control module assembly
(3).
Special tool
: 09950-78220
NOTE:
Put bleeder plug cap onto pipe to prevent fluid from spill-
ing. Do not allow brake fluid to get on painted surfaces.
5) Remove two nuts and disconnect take out ABS hydraulic
unit/control module assembly (1) from bracket using screw-
driver (2).
CAUTION:
• Do not give an impact to hydraulic unit.
• Use care not to allow dust to enter hydraulic unit.
• Do not place hydraulic unit on its side or upside down.
Handling it in inappropriate way will affect its original
performance.
INSTALLATION
1) Install hydraulic unit by reversing removal procedure.
Tightening torque
(a) : 16 N·m (1.6 kg-m, 11.5 lb-ft)
(b) : 9 N·m (0.9 kg-m, 6.5 lb-ft)
(c) : 9 N·m (0.9 kg-m, 6.5 lb-ft)
(d) : 26 N·m (2.6 kg-m, 18.0 lb-ft)
2) Bleed air from brake system referring to "BRAKE" section.
3) Check each installed part for fluid leakage and perform "ABS
Hydraulic Unit Operation Check" in this section.
NOTE:
For new ABS hydraulic unit/control module assembly, if
"ABS Hydraulic Unit Operation Check" procedure has
not been performed, "ABS" warning lamp may flash
when ignition switch is turned ON position.
ANTILOCK BRAKE SYSTEM (ABS) 5E-33