Suzuki Wagon R RB310 Supplementary Service Manual page 227

10B-74 AIR BAG SYSTEM
4 3
If any faulty condition is found in above checks, replace faulty
part.
If any faulty condition is found in above checks, replace.
If any faulty condition is found in above checks, replace.
If any faulty condition is found in above checks, replace.
1
2
If any faulty condition is found in above checks, replace.
• Steering wheel (1) and driver air bag (inflator) module (2)
– Check for damage or air bag (inflator) module fitness.
– Check trim cover (pad surface) for cracks.
– Check wire harness and connector for damage or tight-
ness.
• Contact coil (1) and combination switch assembly
– Check wire harness and connectors for damage or tight-
ness.
– Check contact coil case for damage.
• SDM
– Check for external damage such as deformation, scratch,
crack, peeled paint, etc.
– Check that SDM cannot be installed properly due to a
cause in itself.
– Check that connector or lead wire of SDM has a scorching,
melting or damage.
– Check that connector is connected securely or locked.
– Check SDM connector and terminals for tightness.
– Check SDM sets a diagnostic trouble code (Refer to "DTC
CHECK" in this section.) and the diagnostic table leads to a
malfunctioning SDM.
• Side sensors (if equipped)
– Check sensor (1) and under body (2) for dents, cracks,
deformation or rust.
– Check sensor connector (sensor side and harness side) (3)
or sensor lead wire (4) for damage, crack, scorching or
melting.
• Instrument panel member and reinforcement
– Check for any distortion, bending, cracking or other dam-
age.