Suzuki Wagon R RB310 Supplementary Service Manual page 239

10B-86 AIR BAG SYSTEM
4
5
(A)
1
• For passenger air bag (inflator) module
a) Clear space (1) on ground about 185 cm (6 ft) in diameter
b) Place deployment fixture (A) on ground in step i).
3
Special tool
(A) : 09932-75041
c) Fill plastic reservoir in deployment fixture (A) with water or
4
6
2
d) Attach passenger air bag (inflator) module (2) in deploy-
1
NOTE:
Make sure that deploying direction (6) faces as shown in
figure against mounting attachment (3).
CAUTION:
Be sure to use M8 size and 7T strength bolts and nut (5)
for fixing passenger air bag (inflator) module (2) to
mounting attachment (3).
• For side air bag (inflator) module
a) Clear space (3) on ground about 185 cm (6 ft) in diameter
3
2
b) Place front seat back (2) with side air bag (inflator) module
where passenger air bag (inflator) module for deployment.
Paved, outdoor location where there is no activity is pre-
ferred. If outdoor location is not available, space on shop
floor where there is no activity and provide sufficient ventila-
tion. Ensure no loose or flammable objects are within
deployment area.
sand. This is necessary to provide sufficient stabilization of
fixture during deployment.
ment fixture (A) using mounting attachment (3), hold-down
bolts & nuts (4) and M8 bolts & nuts (5).
where side air bag (inflator) module (1) for deployment.
Paved, outdoor location where there is no activity is pre-
ferred. If outdoor location is not available, space on shop
floor where there is no activity and provide sufficient ventila-
tion. Ensure no loose or flammable objects are within
deployment area.
(1) with its frontal seat cover facing up on ground in step i).