Learning Control Initialization - Suzuki Wagon R RB310 Supplementary Service Manual

Table of Contents

Advertisement

4
12
12
O/D OFF
lamp
1
2
2
1
ON
OFF
3.0
1.0
0.3
0.3

Learning control initialization

When one or more operations such as shown below are per-
formed, all learned contents which are stored in TCM memory
should be erased after the operations.
• Replacing transmission with new or used one.
• Repairing transmission partially by replacing any brake com-
ponent parts with new and/or used brake disc(s), plate(s)
and/or flange.
• Repairing transmission partially by replacing any clutch com-
ponent parts with new and/or used clutch disc(s), plate(s)
and/or flange.
• Replacing TCM with used one.
CAUTION:
Be sure to connect service wire to correct terminal.
Connection to incorrect terminal may cause damage to
TCM.
1) Turn ignition switch ON, leaving engine OFF.
2) Using service wire (1), connect terminal "E12-4" of con-
nected TCM harness side coupler with body ground (3).
3) Shift selector lever from "D" range to "2" range 3 times
repeatedly within 10 seconds with terminal "E12-4" kept on
connecting to body ground.
4) Check flashing pattern of "O/D OFF" lamp (4) with terminal
"E12-4" kept on connecting to body ground and confirm that
only 12 pattern is displayed.
If not, repeat Step 1) to Step 3) and check again.
NOTE:
• "O/D OFF" lamp lights during initializing.
• Diagnostic trouble code(s) (DTC(s)) also are erased by
performing this initializing procedure.
• If initializing is failed, 52 pattern of "O/D OFF" lamp
flashing is displayed.
12
2
1
3.0
Time (sec.)
AUTOMATIC TRANSMISSION (4 A/T) 7B-55

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wagon r rb413

Table of Contents