Making An Emergency Group Call; Receiving An Emergency Group Call; Disaster Alert Call - Motorola MTM800 FuG Feature User Manual

3.6.10 Making an Emergency Group Call

Prerequisites:
Make sure that your radio is in Emergency Mode.
Procedure Steps
1 Press and hold the PTT button.
Wait for the talk permit tone (if configured) and talk.
2
3 Release the PTT button to listen.
To cancel the Emergency Group Call, release the PTT button before the Talk Permit tone is played.

3.6.11 Receiving an Emergency Group Call

A radio receives an Emergency Group Call from the selected pre-programmed group. Audible tone indicates
incoming Emergency Group Call.

3.6.12 Disaster Alert Call

This feature allows you to make Disaster Alert Call in critical and catastrophic situations by making Emergency
Broadcast Call from the radio on a predefined talkgroup. No other services can interrupt this type of the call, except
Emergency or other Disaster Alert call. You can send and receive either in TMO or DMO Mode. Your radio can
receive this type of call on predefined talkgroups. The predefined talkgroups for the Disaster Alert Call are always
scanned. The Disaster Alert Call ends after you release the PTT button.
This call stays clear only, even if any of the encryption services are enabled. The only exception is the
E2E Encryption feature.
Your service provider defines if the Disaster Alert Call is initiated on a predefined talkgroup.
-
3.6.10 Making an Emergency Group Call
3-19