Exiting Emergency Mode; Making An Emergency Group Call; Receiving An Emergency Group Call; Disaster Alert Call - Motorola MTM5400 Feature User Manual

If this Emergency Mode was triggered by Emergency number (not by EMERGENCY button), you can
press the END key to exit the Emergency Mode.

3.6.11 Exiting Emergency Mode

Prerequisites: Make sure that your radio is in Emergency Mode.
Procedure Steps
1 If your radio screen displays Emgcy Mic On, press End.
2 Press and hold Exit.
If Emergency Mode was triggered by Emergency number (not by EMERGENCY button), you can
press the END key to exit the Emergency Mode.
3 If your radio displays Are you sure to exit Emergency?, press Yes to exit.
Result: Your radio exits the Emergency Mode.

3.6.12 Making an Emergency Group Call

Prerequisites: Make sure that your radio is in Emergency Mode.
Procedure Steps
1 Press and hold the PTT button.
2 Wait for the talk permit tone (if configured) and talk.
3 Release the PTT button to listen.

3.6.13 Receiving an Emergency Group Call

A radio receives an Emergency Group Call from the selected pre-programmed group. Audible tone indicates
incoming Emergency Group Call.

3.6.14 Disaster Alert Call

This feature allows you to make Disaster Alert Call in critical and catastrophic situations by making Emergency
broadcast call from the radio on a predefined talkgroup. No other services can interrupt this type of the call, except
Emergency or other Disaster Alert call. You can send and receive either in TMO or DMO Mode. You radio can
receive this type of call on predefined talkgroups. The predefined talkgroups for the Disaster Alert Call are always
scanned. The Disaster Alert Call ends after you release the PTT button.
-
3.6.11 Exiting Emergency Mode
3-15