Table of Contents
Advertisement
1. Installation
1−18
Setting the system diagnosis
With switch element 2 of the 2−element DIL switch 5, you can
set whether the status bits and the I/O diagnostic interface
are to be available in the address range of the CPX terminal
for the system diagnosis.
System diagnosis
No system diagnosis
System diagnosis
(see sections 2.1.6,
Tab. 2/9 and 3.4)
Tab. 1/10: System diagnosis
Please note
If the system diagnosis with the status bits or the I/O diag
nostic interface is used, the word range (RWr and RWw) of
station 1 will be assigned for the system diagnosis.
The system diagnosis is only available in the operating mode
Remote I/O:
In the operating mode Remote Controller, DIL switch 5.2 has
no function.
Further information on the status bits and on the I/O diagnos
tic interface can be found in the sections 2.1 and 3.4.
5
Setting DIL switch 5.2
5.2: OFF
(factory setting)
5.2: ON
Festo P.BE−CPX−FB23−EN en 0308NH
Advertisement
Table of Contents
