Table of Contents
Advertisement
1. Installation
1
Field bus node
CPX−FB23
2
Manifold sub−base
3
Contact rails
4
Screws
Fig. 1/2: Dismantling/fitting the field bus node
Fitting
1−6
4
3
Fit the field bus node as follows:
1. Place the field bus node in the manifold sub−base. Make
sure that the grooves with the terminals for electrical con
tact on the bottom of the field bus node lie directly above
the contact rails. Press the field bus node carefully and
without tilting as far as possible into the manifold sub−
base.
2. Tighten the screws only by hand. Insert the screws so that
the self−boring threads can be used.
Tighten the screws with a Torx screwdriver size T10 with
0.9 ... 1.1 Nm.
Festo P.BE−CPX−FB23−EN en 0308NH
1
2
Advertisement
Table of Contents
