Siemens SIMATIC NET System Manual page 159

On site display (Set button)
C-PLUG slot
● Suitable / available or according to the specified standard
Functions
All devices have the following functions:
● Configuration with the Primary Setup Tool (PST) V3 or higher;
to use the Primary Setup Tool to assign the IP address, the switches must be accessible
via Ethernet.
● Configuration of the IP address with DHCP
● Configuration with STEP 7 V 5.3 plus SP 1
● Web Based Management
● Command Line Interface
● Configuration with STEP 7
● SNMP
● SNTP
● Ring redundancy including RM functionality or RSTP
● Passive listening
● PROFINET diagnostics
● Topology support (LLDP)
● All models are available in two variants: PROFINET and EtherNet/IP The mode can,
however, be switched over as required with both device variants.
● In the EtherNet/IP mode, the devices also have EtherNet/IP diagnostics.
Industrial Ethernet
System Manual, 09/2019, C79000-G8976-C242-10
SCALANCE network components
4.5 SCALANCE X Industrial Ethernet Switches
XB208
XB205-3 (SC)
XB205-3LD (SC)
XB205-3
XB216
XB213-3 (SC)
XB213-3LD (SC)
XB213-3
-
-
159