Advertisement
Unpacking
Siting/Moving the Cooker Your cooker is heavy, so be careful when moving or positioning it. Do not try to
INSTALLATION INSTRUCTIONS
After unpacking your cooker, make sure that you remove all the packing from
the grill compartment and ovens, and any stickers from the oven doors and the
hob.
Examine your cooker for any damage. If there is any damage or anything is
missing, please contact your supplier for advice.
move the cooker by pulling on the doors or handles or control panel. The
Belling Farmhouse is designed to 'slot-in' between 600mm deep cabinets,
spaced approximately 1000mm apart. It can also be used freestanding, with a
cabinet to one side, in a corner setting or with its back to a wall. However it
must not be situated with either side closer than 50mm to a combustible wall or
cupboard that is higher than the cooker. The wall behind the cooker and
450mm above and across the width of the cooker should be of an
incombustible material or easy clean surface such as ceramic tiles. Please
note, when positioning your cooker against a wall, ensure there is sufficient
clearance for the screw heads on the back panel.
This appliance is designed not to project in front of standard 600mm worktops
(excluding handles). To achieve the best fit the cooker must be pushed against
the wall. If the wall mounted adapter backplate (Fig.1) is to be fitted behind the
appliance then the suitable area for this fitting is shown as the area in (Fig.2).
Fig. 1
Fig. 2
6
Hide quick links:
Advertisement
