Dimmer Mode; Led Frequency; Factory Reload; Fixture Information - ProLights MINIECLFRTU-DY User Manual

10

3.7 DIMMER MODE

Enter in Dimmer mode to select specific dimming curve, press the rotary knob to access the main menu.
• Rotate knob to scroll the menu, select Advanced, then press the rotary knob to enter the next menu.
• Rotate knob to scroll through the menu, then select Dimmer mode, and press the rotary knob to confirm.
• Rotate knob to select Off - Dimmer1 - Dimmer2 - Dimmer3.
• Press the rotary knob to confirm your choice.
• Rotate knob and press on ← to go back or to meet the waiting time to exit the setup menu.

3.8 LED FREQUENCY

To adjust the frequency of the LEDs, press the rotary knob to access the main menu.
• Rotate knob to scroll the menu, select Advanced, then press the ENTER button to enter the next menu.
• Rotate knob to scroll through the menu, then select LED Frequency, and press the button ENTER to con-
firm.
• Select the frequency (600Hz - 1200Hz - 2000Hz - 4000Hz - 6000Hz - 25kHz) using the rotary knob buttons.
• To confirm, press the rotary knob.
• Rotate knob and press on ← to go back or to meet the waiting time to exit the setup menu.

3.9 FACTORY RELOAD

Select this function to reset the unit to the factory settings:
• To activate Reset Factory display press the rotary knob to access the main menu.
• Rotate knob to scroll the menu, select Advanced, then press the rotary knob to enter the next menu.
• Rotate knob to scroll through the menu, then select Factory Reload, and press the rotary knob to confirm.
• Rotate knob and press on ← to go back or to meet the waiting time to exit the setup menu.

3.10 FIXTURE INFORMATION

To view all the information on the device, proceed as follows:
• Press the rotary knob to access the main menu.
• Rotate knob button to scroll the menu, select Information, then press the rotary knob to enter the next
menu.
• Rotate knob button to scroll through the menu, then select one of the following information and press
the rotary knob to display it.
- Fixture Time - Through the Fixture Time function you can display the operating time of the projector.
- Software Version - Through Temperature function you can display the temperature of the device.
- Temperature - Through Temperature function you can display the temperature of the device.
- UID - This option shows the RDM identification number.
• Rotate knob and press on ← to go back or to meet the waiting time to exit the setup menu.
3.11 MASTER SLAVE
Press the rotary knob button to access the main menu.
• Rotate knob button to scroll the menu, select Stand Alone, then press the rotary knob to enter the next
menu.
• Rotate knob button to scroll through the menu, select Master/Slave and press the rotary knob to confirm
your choice.
• Rotate knob button to select the mode of operation:
- Master, if the unit is connected in series with other units and it acts as the Master;
- Slave, if the unit is not connected to other units.
MINIECLFRTU - DY