Flashforge Dreamer User Manual page 68

Flashforge Corporation
2.Clogged debris will be pushed down and will extrude from the extruder nozzle. You
should push the unclog too all the way down to ensure all filament is purged. You do
not need to push with excessive force, as this may damage the extruder.
8.3 Daily maintenance and use suggestion
1.Please cover the top and close the front door to prevent the device from falling into
dust when not using the device.If the device has not been used for a long time, it is
recommended to use the original packaging.
2.Grease moving parts regularly.For frequent users, add grease at least once every
three months;For long-term nonusers, add grease at least every six months.
3.Please clean residue and other sundries in time after printing completed, avoid
sundries falling affecting device use.
4. As consumable, build tape may be damaged when adhesive force declined;Please
change build tape in time to avoid affecting print effect.
5.Whenever possible, it is best to locate your object in the center of the build platform.
Using the best orientation for your object is critical. Ensure that your object is located
on the build platform and that you are using the best orientation for building.
6. For steep overhangs (Less than 45 degree angle) it is recommended to build with
support.
Dreamer User Guide | www.flashforge.com
69