Flashforge Dreamer User Manual page 67

Part only built
halfway.
No filament
coming out.
Extruder will not
home.
Stringy or fraying
plastic layers on
steep overhangs.
8.2 Unlogging the extr uder
Use the unclogging tool to clean the extruder and unclog built up filament
1. Click on the filament change button on the screen and wait for extruder to heat up.
As filament starts to purge, insert the unclog tool into the extruder intake (top).
Dreamer User Guide | www.flashforge.com
selected.
Filament ran out.
Filament clogged during
build.
Clogged extruder.
Filament not properly loaded.
／
Object overhangs are too far
apart or too steep (<45 degree
angle).
Flashforge Corporation
Offset.
Replace filament and
resume build. See "No
filament coming out".
Contact customer service.
Try running a lament
change again to ensure the
extruder gears have properly
caught the lament.
Contact customer service.
Build with supports.
68