Auto Suppor ts
②
Click the
[Auto Suppor ts]
are needed and generate corresponding treelike or linear supports. If it is a model with
supports, the existing supports will be deleted and new supports will be generated.
Add Suppor ts
③
Supports will be added once clicking the
position where supports needed, left-click to choose the starting point of supports,
hold down the left mouse button and drag the mouse, the supports preview will show
up (if support surface doesn't need support or the support column angle is too large,
the support review will be highlighted).Loosen the left mouse button, if support
column doesn't meet with model, then support will be generated on origin and
terminal point (the highlighted preview support won't generate support structure)
Clear Suppor ts
④
Click
[Clear Suppor
via clicking
[Undo]
Delete Suppor ts
⑤
Supports will be deleted once clicking the
Dreamer User Guide | www.flashforge.com
6-12
button, the software will judge the position where supports
ts], all supports will be deleted. The operation can be repealed
or pressing the shortcut key
[Add]
button. Move the cursor to the
Ctr
l+Z.
[Delete]
button. Move the cursor to the
Flashforge Corporation
40