Important Safety Instructions; Specifications - B&D Automatic Technology Battery Backup Gen 2 Kit Installation Instructions Manual

Important Safety Instructions

WARNING!
ELECTROCUTION!
CAUTION:
Fall from ladder
Burns

Specifications

Battery Back up Specifications
Approximate number of Cycles under battery power
Average Cycle Time under battery power (Opening and Closing) 40 seconds
Wire Gauge and Length from Battery to Charger board (max)
Battery capacity (Amp Hours)
Time for Re-charge
• DO NOT short the output of batteries. Serious personal injury and/or property
damage can result from failure to follow this warning
• During charging and discharging cycles the lead-acid batteries may release explosive
gases. Ensure that the area around the batteries is well ventilated
• Take care not to allow any metal objects to make contact with the positive and negative
terminals. This will short circuit the battery causing sparks and possible damage to the
battery, or even cause an explosion.
• The battery box unit should be installed away from sprinkler systems.
• DO NOT immerse in water or spray directly with a hose or other device.
• Disconnect the power cord from mains power before making any repairs or removing
covers.
• Ensure ladder is the correct type for job.
• Ensure ladder is on flat ground.
• Ensure user has 3 points of contact while on ladder.
• DO NOT handle damaged or leaking batteries
• Wear appropriate protective clothing and avoid touching your eyes after working with
batteries.
• The battery backup kit contains sealed lead-acid batteries that must be disposed of
properly at the end of their useful life.
6 - 8 Fiveways Boulevard, Keysborough, VIC, Australia 3173
P: 1300 133 944 E: sales@automatictechnology.com.au
W: www.automatictechnology.com.au
Garage Door Swing
10 10
90 seconds
18AWG, 3m 18AWG, 3m
2.3 AH 2.3 AH
24 - 48 Hours 24 - 48 Hours
Slider
10
90 seconds
18AWG, 3m
2.3 AH
24 - 48 Hours