Fisher & Paykel AeroSmart Series Installation Instructions And User Manual page 61

Solving d 'ying p 'oblems
Have you over-dried your load? Over-drying can cause lint-attracting static electricity Try a
lower Dryness Setting or use AUTO-SENSING instead of TIME DRY_
Is the lint bucket in place?
Have your clothes been over-dried? Choose a lower dryness setting,
Have you used fabric softener? Place fabric softener sheets in the dryer
Has the load been over-dried? Choose a lower dryness setting
Is tumble-drying recommended? Check care labels inside garments,
If you selected TIME DRY - did you set it to dry for too long?
Has the correct temperature been used to dry the garment? Check the care label
Does the load sit higher than the lint bucket? Your dryer s over--loaded, decrease the load
size.
Did you remove your clothes as soon as the dryer was finished7 Use the WRINKLE FREE
option, if you cannot return to the dryer in time.
Have your clothes been over-dried? Select a lower dryness levek Check your garments care-
labels
Is the electrical cord plugged in? If not, plug the cord in and switch power on,
A power failure may have occurred Please refer to page 52 for more information, or contact
your Fisher& Paykel Authorised Service Agent
is the WRINKLE FREEoption selected7 Press START/PAUSE to open the lid
Your dryer may be experiencing a low voltage supply, Without enough electricity it cannot
function Once the line voltage returns to normal the dryer will recommence the interrupted
cycle f the problem persists call for service,