Fisher & Paykel AeroSmart Series Installation Instructions And User Manual page 25

iiii}iilliiii ¸ii'ii ¸ii'iiiiill ¸iiilliiii '}}}ii
IIInstalllllation insWuctions
Electrical connections (electric models only)
Please read Electrical requirements and grounding instructions on pages 20 - 21 fkst_
Electric models of the dryer are manufactured for a 3-wire connection system, The dryer frame
is grounded by a link to the neutral conductor on the dryer terminal block If local codes do
not permit grounding through the neutral, the grounding link from the terminal block must be
removed and a separate ground wire must be used,
The grounding link on the dryer must be removed for all &wire installations including new
remodelled construction, or mobile homes,
These Electrical Connection instructions provide for installing the dryer in the following
situations:
3--wire connection where local codes permit grounding through the neutral.
3-wire connection plus separate grounding connector where local codes do not permit
grounding through the neutral.
&wire connection.
Each of the above connections can be made with an approved power supply cord or by direct
wiring. Each connection instruction identifies the appropriate Power Supply Cord and covers
requirements for direct wiring.
For 3_-wire connections by power cords
3-wire power supply cord must have three 10 AWG copper wires and match a 3-wire receptacle
!
For 3owire connections by direct wiring
1O-gauge, 3wire with
ground wire (Romex)
14
,Ng.21 Wiring 3wire conneclions